Nortel Communication Server 100 Manual page 158

158 Carrier Remote IPE maintenance
Newly installed Carrier Remote IPE
Problems that occur during the installation of an entire system including
the Carrier Remote IPE are usually caused by:
•
improperly installed cards
•
loose or improperly connected external communication cables, internal
cables, or carrier link cables
•
incorrect software version
•
incorrect Carrier Remote IPE configuration
These types of problems can also occur when:
•
installing additional Carrier Remote IPE equipment into an already
operating system
•
installing a new software version or changing the Carrier Remote IPE
configuration
Check the symptoms listed in
problems" (page 160)
Carrier Remote IPE.
Previously operating Carrier Remote IPE
Problems that occur during the normal operation of Carrier Remote IPE
are usually caused by:
•
faulty equipment
•
accidental disconnection of cables
•
improper environmental conditions
Check the symptoms listed in
equipment problems" (page 160)
previously-operating Carrier Remote IPE.
System fault isolation and correction
To isolate Carrier Remote IPE faults in the system, first isolate and correct
the common, network, and power equipment faults to make the system
non-Carrier Remote IPE functions operational. Then proceed with fault
isolation and fault correction of Carrier Remote IPE functions.
To aid in isolating the problems in a systematic way, use the fault isolation
and correction tables. These tables provide a guide through logical steps
to determine the cause of the problem based on the visual fault indicators
and system fault messages.
that are related to problems with a newly-installed
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Table 30 "Carrier Remote IPE equipment
Table 30 "Carrier Remote IPE
that are related to problems with a