Nortel Communication Server 100 Manual page 171

To start the self-test, follow the steps in
Remote Carrier Interface card self-test" (page
Procedure 40
Performing the Remote Carrier Interface card self-test
Step Action
1 Log in on the maintenance terminal as described in
system maintenance programs" (page
2 At the > prompt, type LD 32 and press the Enter key to access
the Network and IPE Diagnostic Program.
3 Type DSXP x and press the Enter key to disable the Remote
Carrier Interface card, where x is the number of the Remote
Carrier Interface card to be disabled.
4 Type XPCT x and press the Enter key to start the self-test,
where x is the Remote Carrier Interface card specified for
self-test.
If the response is
TEST PASSED
the Remote Carrier Interface card passed the self-test
and is functional but must be enabled to turn off the red
LED and to start processing calls.
Type ENXP x (v) and press the Enter key to enable
the card and the associated IPE cards, where x is the
Remote Carrier Interface card number and (v) is the
optional download software version v.
If the Remote Carrier Interface card passed the self-test,
but the problem persists, the carrier link or other cards
that interface with the Remote Carrier Interface card may
be faulty. To verify the integrity of the peripheral bus and
the Remote Carrier Interface card, go to
"Performing the Remote Carrier Interface card loopback
test" (page
If the response is
TEST FAILED
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Carrier Remote IPE fault isolation and correction 171
Procedure 40 "Performing the
171).
173).
REASON: xxxx
"Using
154).
Procedure 41