Nortel Communication Server 100 Manual page 13

Carrier Interface card. The carrier type is switch-selected on the Local
Carrier Interface card.
assignment" (page 197)
assignments for all external connectors on the I/O panel assemblies.
Table 2
Local site carrier hardware list
Component
NT7R51 Local Carrier
Interface card
NT7R66AA SDI Cable
Kit
NT7R66BA MMI Cable
NT7R67BA Local
Carrier/Monitor Cable
Assy
NT7R67CA Local
Daisy-chain Cable
Assy
"Connection diagrams and external connectors pin
provides connection diagrams and connector pin
Description
Local Carrier Interface card installed in a network card slot.
This cable kit provides a DB-9 male to DB-25 male 10-foot cable and a
DB-25F/DB-25F adapter. To connect the standard SDI card to the DB-9
female P2 connector of the NT7R67DA cable at the local site, you would
use the entire kit except for the DB-25F/DB-25F adapter, which is used
with the SDI Paddleboard.
This is a DB-9 female to DB-25 male (32 ft) cable. Connect the MMI
terminal to the DB-9 male P3 connector of the NT7R67DA cable at the
local site and directly to the MMI port of the Carrier Remote IPE site.
This cable assembly connects the Local Carrier Interface to the network
I/O panel. It consists of the NT7R67HA cable, the NT7R57AA Carrier
Panel assembly, and the NT7R58AA Maintenance Panel assembly. The
P1 DB-25 male connector plugs into the faceplate, the P2 DB-15HD
male connector plugs into the NT7R58AA Maintenance Panel assembly,
which provides two 6-pin modular system monitor jacks and one DB-9
female MMI maintenance connector. The P3 DB-15HD female connector
plugs into the NT7R57AA Carrier Panel assembly, which provides three
8-pin modular carrier jacks. Refer to Appendix C,
LCI connection diagram (local site connections)" (page
"Multiple LCIs connection diagram (local site daisy-chain connection)"
(page 199), and Figure 30 "Local site system monitor connection diagram
(single and multiple LCI configuration)" (page
This cable provides P1 DB-9 male connector that plugs into the faceplate
and P2 DB-9 male connector that plugs into the NT7R58AA Maintenance
Panel assembly. This cable is used with multiple Local Carrier Interface
cards in a daisy-chain configuration or in a single Local Carrier Interface
configuration to connect the MMI terminal. Refer to Appendix C,
26 "Single LCI connection diagram (local site connections)" (page
Figure 27 "Multiple LCIs connection diagram (local site daisy-chain
connection)" (page 199), and
connection diagram (single and multiple LCI configuration)" (page
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
System description 13
Figure 26 "Single
202).
Figure 30 "Local site system monitor
198), Figure 27
Figure
198),
202).