Adjusting the Film Detector Switches
Adjusting the ACTUATORS
[1]
Adjust the position of the drive side ACTUATOR.
(a)
Place the DETECTOR CROSSOVER on a flat work surface with the drive side toward you. See
the figure below.
(b)
Check that the ACTUATOR is in the ''IN'' position. See the figure.
If the ACTUATOR is in the ''OUT'' position:
1.
Loosen the SCREW.
2.
Move the ACTUATOR to the ''IN'' position.
3.
Tighten the SCREW.
2B6845
IMPORTANT
Do all 3 adjustments to the DETECTOR SWITCHES.
ACTUATOR
SCREW
Adjusting the Position of the Actuator on the
Drive Side of the Detector Crossover
IN
OUT
H104_0376BCA
H104_0376BA
6-23