Removing The Dryer End Bearing From The Drive Shaft - Kodak X-Omat 270 RA Service Manual

Removing the Dryer End Bearing from the Drive Shaft

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove:
• DRIVE SIDE PANEL
• EXIT PANEL
• DRIVE CHAIN COVER
[4] Remove the E-RING and the DRIVE SHAFT
WASHERS from the FEED END of the DRIVE
SHAFT.
[5] For access to the the SPROCKET PIN, move
the DRIVE SHAFT toward the DRYER END.
DRIVE
CHAIN
DRIVE
CHAIN
COVER
2B6845
H104_0147CCE
H104_0147CA
Replacement of the Dryer End Bearing on the Drive Shaft
[6] Remove:
• SPROCKET PIN
• DRIVE CHAIN
• SPROCKET
• 2 THRUST WASHERS
• THRUST BEARING
• BEARING RETAINER
• BEARING
[7] Install a new BEARING.
[8] Reverse the above procedure to assemble the
other parts removed.
PUNCH
SPROCKET
PIN
DRYER
END
THRUST
WASHERS
BEARING
SPROCKET
BEARING
RETAINER
THRUST
BEARING
FEED END
DRIVE
SHAFT
DRIVE
ROLL PIN SHAFT
WASHER
E-RING
H104_0148CCC
H104_0148CA
3-9