Removing The Fixer Thermistor Rt2 - Kodak X-Omat 270 RA Service Manual

Removing the Fixer Thermistor RT2

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the DRIVE SIDE PANEL.
[4] Use 2 CLAMPS TL-2170 on the 2 HOSES to
the FIXER THERMOWELL.
[5] Disconnect the CONNECTOR P/J 27.
[6] Remove the FIXER THERMISTOR from the
FIXER THERMOWELL.
Use SEALANT TL-3230 on the threads
when you install the FIXER
THERMISTOR. Use only TL-3230.
Any other SEALANT will corrode the
plastic in the THERMOWELL. See the
instructions packaged with the
SEALANT.
[7] Reverse the above procedure to install a new
FIXER THERMISTOR and to assemble the
PROCESSOR.
[8] Check for leakage at the FIXER
THERMOWELL.
2B6845
FIXER
THERMISTOR
FIXER
THERMOWELL
CONNECTOR CONNECTOR
P/J 27
H104_0162CCB
H104_0162CA
Replacement of the Fixer Thermistor
CLAMP
TL-2170
5-11