Removing A Solid State Relay - Kodak X-Omat 270 RA Service Manual

Removing a Solid State Relay

Possible damage from electrostatic discharge.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the EXIT PANEL.
[4] Extend the ELECTRICAL BOX.
[5] Open the COVER of the ELECTRICAL BOX.
[6] Remove:
• 2 SCREWS
• 2 SPACERS
• RELAY COVER
[7] Record the 4 wire positions on the SOLID
STATE RELAY that you want to remove.
SCREW (2)
SPACER (2)
SCREW (4)
SOLID
STATE
RELAY
6-12
RELAY
COVER
MOUNTING
SCREW (2)
Replacement of the Solid State Relay in the Electrical Box
[8] Remove the 4 SCREWS that hold the wires to
the SOLID STATE RELAY.
[9] Remove the 2 MOUNTING SCREWS from the
SOLID STATE RELAY.
[10] Lift the SOLID STATE RELAY from the
ELECTRICAL BOX.
[11] Apply THERMAL GREASE TL-2324 under the
SOLID STATE RELAY. Use a thin
application, but cover the area under the
SOLID STATE RELAY completely.
[12] Reverse the above procedure to install new
SOLID STATE RELAYS and to assemble the
PROCESSOR.
COVER
ELECTRICAL
BOX
H104_0443HCA
H104_0443HA
2B6845