Kodak X-Omat 270 RA Service Manual page 89

Prevent contamination of the developer
and fixer solutions when removing the
FIXER RACK and the DEVELOPER
RACK, by placing the SPLASH
GUARD between the DEVELOPER
TANK and the FIXER TANK. Use the
DRIP TRAY for removal or installation
of the RACKS.
SPLASH
GUARD
[5] Install the SPLASH GUARD between the
DEVELOPER TANK and the FIXER TANK.
[6] Remove:
(a) FIXER RACK
(b) SPLASH GUARD
(c) DEVELOPER RACK
[7] Rinse all RACKS and CROSSOVERS with
warm water, 44°C (110°F) or less. Wipe the
ROLLERS and the GUIDE SHOES with a
soft, synthetic sponge.
[8] Remove and clean the CROSSOVER
TROUGHS. Check that the holes in the
CROSSOVER TROUGHS are free from
biological growth or other obstructions.
[9] Install the CROSSOVER TROUGHS.
2B6845
DRIP
TRAY
H108_0035ACC
H108_0035AA
[10] On all RACKS, check:
(a) That all ROLLERS rotate freely
(b) That the ROLLERS are clean and
smooth
(c) That the GEARS do not have
excessive wear or burrs
(d) That the BEARINGS do not have
excessive wear
(e) For broken, missing, or corroded
E-RINGS and SPRINGS
[11] If necessary, install new parts.
[12] Check the RACKS for squareness. See
pages 2-3 and 2-4.
[13] Check that the AIR TUBES are installed in the
correct positions in the DRYER RACK. See
the diagram on the DRYER COVER of the
DRYER RACK.
[14] Check that the SLOTS in the AIR TUBES are
clean. If necessary, clean the AIR TUBES
with a bottle brush and rinse with water.
[15] Wipe any chemical deposits from the
processing section of the PROCESSOR.
[16] Change the DEVELOPER FILTER. See
page 5-6.
[17] Allow the DETECTOR CROSSOVER to air
dry before you install it in the PROCESSOR.
[18] Install the RACKS.
[19] Connect the WATER DISCONNECT.
[20] Install:
• CROSSOVERS
• YOKE
• EVAPORATION COVERS
• WET SECTION COVER
[21] Check that each assembly seats firmly.
[22] Clean the REPLENISHER STRAINERS that
are between the REPLENISHMENT TANKS
and the REPLENISHMENT PUMPS.
[23] Check the water supply FILTER. If
necessary, change the FILTER.
7-3