Removing The Blower Assembly B1 - Kodak X-Omat 270 RA Service Manual

Removing the Blower Assembly B1

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove:
• NON-DRIVE SIDE PANEL
• EXIT PANEL
• 3 SCREWS, the 3 LOCK WASHERS, and
the 3 WASHERS holding the BLOWER
ASSEMBLY to the BASE PLATE
• BLOWER SLEEVE from the PLENUM
CONNECTOR
P/J 18
SCREW (3)
LOCK WASHER (3)
WASHER (3)
BLOWER
ASSEMBLY
4-2
BLOWER
SLEEVE
Replacement of the Blower Assembly
[4] Pull the BLOWER ASSEMBLY toward you
and remove it from the PROCESSOR.
[5] Disconnect the CONNECTOR P/J 18.
[6] Reverse the above procedure to install the
new BLOWER ASSEMBLY and to assemble
the other parts removed.
BASE PLATE
PLENUM
H104_0409HCA
H104_0409HA
2B6845