Removing The 200 Circuit Board, The Control Interface - Kodak X-Omat 270 RA Service Manual

Removing the 200 Circuit Board, the Control Interface

Possible damage from electrostatic discharge.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Remove:
• 2 SCREWS from the CONTROL
INTERFACE PANEL
• CONTROL INTERFACE PANEL from the
PROCESSOR
• 3 CONNECTORS from the 200 CIRCUIT
BOARD
• 2 MOUNTING SCREWS from the
200 CIRCUIT BOARD
• 2 CONNECTOR SCREWS from the PIC
CONNECTOR
• 200 CIRCUIT BOARD from the CONTROL
INTERFACE PANEL
CIRCUIT
BREAKER
CB1
2B6845
CONNECTOR (3)
PIC CONNECTOR
Replacement of the 200 Circuit Board, the Control Interface
[3] Reverse the above procedure to install a new
200 CIRCUIT BOARD and to assemble the
PROCESSOR.
MOUNTING
SCREW (2)
200 CIRCUIT
BOARD
CONNECTOR
SCREW (2)
SCREW (2)
CONTROL
INTERFACE
PANEL
H104_0150BCB
H104_0150BA
6-9