Developer Recirculation System; Removing The Recirculation Pump B5 - Kodak X-Omat 270 RA Service Manual

Developer Recirculation System

Removing the Recirculation Pump B5

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the DRIVE SIDE PANEL.
[4] Remove the SPLASH COVER.
[5] Remove the 2 SCREWS, the 2 LOCK
WASHERS, and the 2 WASHERS that hold
the RECIRCULATION PUMP to the PUMP
BASE PLATE.
[6] Move the RECIRCULATION PUMP for better
access to the HOSES.
[7] Use 4 CLAMPS TL-2170 on the 2 developer
HOSES and on the 2 fixer HOSES to the
RECIRCULATION PUMP.
[8] Loosen the 4 HOSE CLAMPS and remove the
2 developer HOSES and the 2 fixer HOSES
from the RECIRCULATION PUMP.
[9] Disconnect the CONNECTOR P/J 12.
[10] Remove the RECIRCULATION PUMP.
[11] Reverse the above procedure to install a new
RECIRCULATION PUMP.
5-2
RECIRCULATION
PUMP
SCREW (2)
WASHER (2)
LOCK
WASHER (2)
PUMP
BASE
PLATE
SPLASH
COVER
Replacement of the Recirculation Pump
CONNECTOR
P/J 12
TL-2170
CLAMP
H104_0154CCA
H104_0154CA
2B6845