Removing The Developer Or Fixer Replenishment Pump, B3 Or B4 - Kodak X-Omat 270 RA Service Manual

Removing the Developer or Fixer Replenishment Pump, B3 or B4

The procedure for removing the
developer REPLENISHMENT PUMP is
the same as for removing the fixer
REPLENISHMENT PUMP, except for
the quantity of SCREWS.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the NON-DRIVE SIDE PANEL.
[4] Use 2 CLAMPS TL-2170 on the 2 HOSES at
the REPLENISHMENT PUMP.
[5] Loosen the HOSE CLAMPS and remove the
2 HOSES from the REPLENISHMENT PUMP.
[6] Remove the 2 SCREWS, the LOCK
WASHERS, and the WASHERS from the
PUMP BASE PLATE.
[7] Disconnect the CONNECTOR P/J 15 for the
developer, or P/J 16 for the fixer.
MOTOR
COVER
MOTOR
HOUSING
developer
REPLENISHMENT
PUMP
fixer
REPLENISHMENT
PUMP
5-14
NOTE
Replacement of the Developer or Fixer Replenishment Pump
[8] Remove the REPLENISHMENT PUMP.
[9] Reverse the above procedure to assemble.
Clamp TL-2170
H104_0257AA
H104_0023BCE
H104_0023BA
2B6845