Installing And Adjusting The Feed Shelf - Kodak X-Omat 270 RA Installation Instructions Manual

[1] Using the 4 SCREWS, 4 LOCK WASHERS,
and 4 WASHERS, install the FEED SHELF
onto the PROCESSOR.
Do not tighten the SCREWS.
[2] Adjust the position of the FEED SHELF to
approximately 1 mm (1/16 in.) below the NIP
of the DETECTOR CROSSOVER ENTRANCE
ROLLERS.
[3] Tighten the 4 SCREWS.
30

Installing and Adjusting the Feed Shelf

NOTE
SCREW (4)
Figure 25 Installing the Feed Shelf
1mm (1/16 in.)
Figure 26 Adjusting the Feed Shelf
H104_0045ACA
FEED SHELF
DETECTOR
CROSSOVER
ENTRANCE
ROLLERS
NIP
SCREW (4)
H108_0038ACA
H104_0475AA
2B6843