Preventive Maintenance; Weekly Preventive Maintenance - Kodak X-Omat 270 RA Service Manual

Hide thumbs Also See for X-Omat 270 RA:

Service manual (36 pages)

Installation instructions manual (34 pages)

Table Of Contents

Table of Contents

Reliable operation of the PROCESSOR requires that all parts are cleaned, adjusted, and

lubricated correctly. More frequent maintenance may be necessary because of site characteristics

or actual usage. The following guidelines are for PROCESSORS installed according to the site

specifications.

Weekly Preventive Maintenance

[1]

Deenergize the PROCESSOR. See page 1-5.

[2]

Lift the TOP COVER.

[3]

Remove the WET SECTION COVER, the EVAPORATION COVERS, all CROSSOVERS, and the WASH

RACK.

[4]

Rinse the 3 CROSSOVERS and the WASH RACK with warm water, 44°C (110°F) or less. Wipe the

ROLLERS and the GUIDE SHOES with a damp, soft, synthetic sponge.

[5]

Allow the DETECTOR CROSSOVER to air dry before you install it in the PROCESSOR.

[6]

Check that all ROLLERS on all CROSSOVERS and on the WASH RACK rotate freely. Check the

squareness of the CROSSOVERS and the WASH RACK. See pages 2-3 and 2-4.

[7]

Check that the CROSSOVER TROUGHS are not broken or do not have cracks.

[8]

Install the WASH RACK, the CROSSOVERS, the EVAPORATION COVERS, and the WET SECTION

COVER. Check that each assembly seats firmly.

[9]

Wipe any chemical deposits from the processing section of the PROCESSOR.

[10]

Energize the PROCESSOR and check for correct operation.

[11]

Process a test film and check the transport assemblies.

2B6845