Removing The Impeller Housing Or The Impeller - Kodak X-Omat 270 RA Service Manual

Removing the Impeller Housing or the Impeller

Use this procedure for either the
developer IMPELLER HOUSING or the
fixer IMPELLER HOUSING.
[1] Remove the RECIRCULATION PUMP. See
page 5-2.
[2] Remove the 4 WING NUTS from the
IMPELLER HOUSING.
[3] Remove the IMPELLER HOUSING from the
RECIRCULATION PUMP.
To prevent chemical contamination, do
not interchange the developer and fixer
IMPELLERS or the developer and fixer
IMPELLER HOUSINGS.
[4] Remove:
• SCREW
• WASHER
• IMPELLER
[5] Check the O-RING for wear. If necessary,
install a new O-RING.
[6] To prevent leakage, check that the O-RING is
correctly seated.
[7] Reverse the above procedure to install new
parts and to assemble the PROCESSOR.
2B6845
NOTE
IMPELLER
WASHER
SCREW
IMPELLER HOUSING
Replacement of the Impeller Housing
or the Impeller
O-RING
WING
NUT (4)
H104_0033ACA
H104_0033AA
5-3