Kodak X-Omat 270 RA Service Manual page 82

[2] Adjust the Position of the non-drive side ACTUATOR.
(a) Place the DETECTOR CROSSOVER on a flat work surface with the non-drive side toward you.
See the figure below.
(b) Check that the ACTUATOR is in the ''IN'' position. See the figure.
If the ACTUATOR is in the ''OUT'' position:
1. Loosen the SCREW.
2. Move the ACTUATOR to the ''IN'' position.
3. Tighten the SCREW.
[3] Install the DETECTOR CROSSOVER in the PROCESSOR.
6-24
IN
OUT
Adjusting the Position of the Actuator on the
Non-Drive Side of the Detector Crossover
ACTUATOR
SCREW
H104_0375BCA
H104_0375BA
2B6845