Removing The Air Flow Switch S3 - Kodak X-Omat 270 RA Service Manual

Removing the Air Flow Switch S3

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the NON-DRIVE SIDE PANEL and
the EXIT PANEL.
The PLENUM ASSEMBLY COVER may be hot.
[4] Remove the 6 SCREWS and the PLENUM
ASSEMBLY COVER.
[5] Disconnect the CONNECTOR P/J 24 from the
AIR FLOW SWITCH S3.
[6] Disconnect and remove the AIR FLOW
SWITCH from the SWITCH BRACKET.
PLENUM
ASSEMBLY
COVER
AIR FLOW SWITCH S3
2B6845
SWITCH
BRACKET
CONNECTOR P/J 24
Replacement of the Air Flow Switch
When you install a new AIR FLOW
SWITCH, check that all the wires are
in the correct openings in the PLENUM
ASSEMBLY COVER and are not
pinched.
[7] Reverse the above procedure to install a new
AIR FLOW SWITCH and to assemble the
PROCESSOR.
SCREW (6)
H127_0028BCB
H127_0028BA
4-7