Kodak X-Omat 270 RA Service Manual page 27

[6] Remove from the FEED END of the DRIVE
SHAFT:
• E-RING
• DRIVE SHAFT WASHER
[7] For access to the SPROCKET PIN, move the
DRIVE SHAFT toward the DRYER END of the
PROCESSOR.
[8] Remove from the DRYER END of the DRIVE
SHAFT the:
• SPROCKET PIN
• SPROCKET
• 2 THRUST WASHERS
• THRUST BEARING
• BEARING RETAINER
• BEARING
To prevent damage to the SCREWS,
loosen all 4 SCREWS before removing
the 4 SCREWS from the BEARING
MOUNT.
[9] Loosen the 4 SCREWS that hold the
BEARING MOUNT.
[10] Remove:
• 4 SCREWS
• 4 LOCK WASHERS
• 4 WASHERS
• BEARING MOUNT
• any SHIM
• SHIELD
Observe the quantity of SHIMS removed. When assembling the DRIVE SHAFT, install the same
quantity of SHIMS. See page 3-4.
[11] Remove the DRIVE SHAFT by slowly pulling it toward the DRYER END of the PROCESSOR.
[12] If necessary, remove any WORM GEARS that have wear from the DRIVE SHAFT. Use a PUNCH to
remove the ROLL PIN from the WORM GEAR.
2B6845
SPROCKET
PIN
DRYER
END
BEARING
MOUNT
THRUST
WASHERS
BEARING
SPROCKET
THRUST
BEARING
Removing the Drive Shaft and the Worm Gears
IMPORTANT
WORM
GEAR (7)
PUNCH
DRIVE
SHAFT
ROLL PIN
SHIELD
SCREW (4)
WASHER (4)
BEARING
LOCK WASHER (4)
RETAINER
FEED END
DRIVE
SHAFT
WASHER
E-RING
SHIM
H104_0148CCB
H104_0148CA
3-3