Removing The Feed End Bearing From The Drive Shaft - Kodak X-Omat 270 RA Service Manual

Removing the Feed End Bearing from the Drive Shaft

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the DRIVE SIDE PANEL and the
CIRCUIT BREAKER COVER.
[4] Remove the E-RING and the DRIVE SHAFT
WASHER from the DRIVE SHAFT.
[5] Remove the BEARING RETAINER.
[6] Remove the BEARING from the FEED END
of the DRIVE SHAFT.
3-8
DRIVE
SHAFT
Replacement of the Feed End Bearing on the Drive Shaft
[7] Install a new BEARING.
IMPORTANT
When installing the new BEARING,
install a quantity of DRIVE SHAFT
WASHERS until the DRIVE SHAFT
has minimum play from side to side.
[8] Reverse the above procedure to assemble the
other parts removed.
BEARING
RETAINER
FEED END
E-RING
DRIVE
SHAFT
WASHER
BEARING
BEARING
MOUNT
CIRCUIT
BREAKER
COVER
H104_0432HCA
H104_0432HA
2B6845