Removing The Quad Power Supply A1 - Kodak X-Omat 270 RA Service Manual

Removing the Quad Power Supply A1

Possible damage from electrostatic discharge.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the EXIT PANEL.
[4] Extend the ELECTRICAL BOX.
[5] Open the COVER of the ELECTRICAL BOX.
COVER
CONNECTOR (3)
6-16
POWER
SUPPLY
COVER
Replacement of the Quad Power Supply
[6] Remove:
• 2 SCREWS
• 2 LOCK WASHERS
• 2 WASHERS
• POWER SUPPLY COVER with the FAN
• 4 SCREWS that hold the QUAD POWER
SUPPLY
[7] Disconnect the 2 CONNECTORS.
[8] Remove the QUAD POWER SUPPLY.
[9] Reverse the above procedure to install a new
QUAD POWER SUPPLY and to assemble the
PROCESSOR.
FAN
QUAD
POWER SUPPLY
SCREW (2)
LOCK WASHER (2)
WASHER (2)
SCREW (4)
H104_0440HCA
H104_0440HA
2B6845