Removing The Developer Cooling Solenoid L2 - Kodak X-Omat 270 RA Service Manual

Removing the Developer Cooling Solenoid L2

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the DRIVE SIDE PANEL.
[4] Use 2 CLAMPS TL-2170 on the 2 HOSES to
the COOLING SOLENOID for the developer.
[5] Remove the HOSE CLAMPS and the HOSES.
[6] Remove the 2 SCREWS from the COOLING
SOLENOID.
[7] Disconnect the CONNECTOR P/J 23 and the
ground wire at the COOLING SOLENOID.
[8] Remove the COOLING SOLENOID.
[9] Remove and keep the 2 FITTINGS.
FITTING (2)
COOLING
SOLENOID
SCREW (2)
2B6845
CONNECTOR
P/J 23
HOSE
CLAMP
HOSE (2)
Replacement of the Developer Cooling Solenoid
• Install the COOLING SOLENOID with
the C on the bottom and the A on
the top.
• Use SEALANT TL-3230 on the FITTINGS.
Use only TL-3230. Any other SEALANT will
corrode the plastic in the THERMOWELL.
See the instructions packed with the
SEALANT.
• Do not overtighten the parts during
installation of the COOLING SOLENOID.
[10] Reverse the above procedure to install a new
COOLING SOLENOID and to assemble the
PROCESSOR.
[11] Check for leakage at the COOLING
SOLENOID.
CLAMPS
TL-2170
H104_0438HCA
H104_0438HA
5-7