Removing The Dryer Heater Hr3 - Kodak X-Omat 270 RA Service Manual

Removing the Dryer Heater HR3

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the NON-DRIVE SIDE PANEL and
the EXIT PANEL
The PLENUM ASSEMBLY COVER
may be hot. Allow it to cool before you
remove the DRYER HEATER.
[4] Remove the 6 SCREWS and the PLENUM
ASSEMBLY COVER.
DRYER
HEATER
PLENUM
CONNECTOR
ASSEMBLY
P/J 21
COVER
2B6845
SCREW (2)
CABLE
SHIELD
CONNECTOR
Replacement of the Dryer Heater
[5] Disconnect CONNECTOR P/J 21 from the
DRYER HEATER.
[6] Remove the CABLE SHIELD CONNECTOR
from the PLENUM ASSEMBLY COVER.
[7] Remove the 2 SCREWS holding the DRYER
HEATER to the PLENUM ASSEMBLY
COVER.
[8] Remove the DRYER HEATER from the
PROCESSOR.
SCREW (6)
H104_0411HCA
H104_0411HA
4-5