Cleaning The Spray Bars In The Wash Rack - Kodak X-Omat 270 RA Service Manual

Cleaning the Spray Bars in the Wash Rack

• The holes in the SPRAY BARS in
the WASH RACKS can become
clogged from the minerals in the
water supply. For correct operation
of the WASH RACK, clean the
SPRAY BARS periodically. The
characteristics of the water supply
determine the frequency of cleaning.
• PROCESSORS with Mod 17 installed do not
have SPRAY BARS.
[1] Deenergize the PROCESSOR. See page 1-5.
YOKE
2B6845
NOTE
Removing the Wash Rack from the Processor
[2] Lift the TOP COVER.
[3] Remove the WET SECTION COVER and the
EVAPORATION COVERS.
[4] Disconnect the WATER DISCONNECT on the
non-drive side of the WASH RACK.
[5] Lift the YOKE from the FIXER/WASH
CROSSOVER.
[6] Remove the FIXER/WASH CROSSOVER.
[7] Lift the WASH RACK slowly from the
PROCESSOR.
[8] Set the WASH RACK on a table.
FIXER/WASH
CROSSOVER
WASH RACK
H104_0153BCD
H104_0153BA
2-7