Kodak X-Omat 270 RA Service Manual page 23

[13] To clean the insides of the SPRAY BARS,
use SPECIAL TOOL TL-4460 and:
• water or
• a mild solution of water and vinegar or
• Kodak FIXER/WASH SYSTEM CLEANER
• Do not make the holes in the SPRAY
BARS larger when inserting objects.
If using a drill bit, manually insert
the non-cutting end into the holes.
• If using Kodak SYSTEM CLEANER, see the
directions and cautions packed with the
SYSTEM CLEANER. Rinse the SPRAY
BARS thoroughly.
[14] If necessary, manually insert a small object,
such as the non-cutting end of a small drill bit,
into each of the holes in the SPRAY BARS to
clean the holes.
[15] Rinse the SPRAY BARS.
[16] Check that the O-RINGS are correctly seated
in the SPRAY BAR MOUNTS.
The SPRAY BARS must be fully
seated in the SPRAY BAR MOUNTS
to install the SPRAY BAR MOUNTS in
the WASH RACK. Immersing the
SPRAY BARS and the SPRAY BAR
MOUNTS in water makes installation
easier.
[17] Insert the KEYED ENDS of the 2 SPRAY
BARS into the drive side SPRAY BAR
MOUNT.
[18] Rotate the SPRAY BARS until the KEYED
ENDS are seated fully in the SPRAY BAR
MOUNT.
2B6845
[19] Install the other ends of the 2 SPRAY BARS
in the non-drive side SPRAY BAR MOUNT.
[20] Install the drive side SPRAY BAR MOUNT in
the WASH RACK.
[21] Install the 2 SCREWS that hold the SPRAY
BAR MOUNT.
[22] Check the squareness of the WASH RACK.
See the figure below or page 2-4.
[23] Connect the YOKE HOSE to the STANDOFF
CLIP.
[24] Return the WASH RACK slowly and
carefully into position in the PROCESSOR.
[25] Connect the WATER DISCONNECT.
[26] Install the:
• FIXER/WASH CROSSOVER
• YOKE
• EVAPORATION COVER
• WET SECTION COVER
[27] Check that the PROCESSOR operates
correctly.
SIDE
PLATE (2)
Checking the Squareness of the Wash Rack
SIDE PLATE
SCREW (6)
H104_0139ACA
H104_0139AA
2-9