Kodak X-Omat 270 RA Service Manual page 11

[9] To install the RACKS:
To prevent contamination of the
developer when installing the
DEVELOPER RACK and the FIXER
RACK,
• Use the SPLASH GUARD.
• Install the FIXER RACK first.
(a) Place the SPLASH GUARD between
the developer and fixer TANKS.
(b) Slowly install the FIXER RACK in the
fixer TANK.
(c) Remove the SPLASH GUARD.
(d) Slowly install the DEVELOPER RACK.
(e) Install:
• WASH RACK
• DETECTOR CROSSOVER
• FIXER/WASH CROSSOVER
• DEVELOPER/FIXER CROSSOVER
• DRYER RACK
TOP EXIT
RACK
H104_0386BCB
H104_0386BA
Engaging the Locking Tabs on the Top Exit Rack and the Dryer Rack
2B6845
(f) If the PROCESSOR has a TOP EXIT
RACK, install the TOP EXIT RACK.
IMPORTANT
The 4 LOCKING TABS must engage.
Check that the LOCKING TABS on the TOP EXIT
engage the LOCKING TABS on the DRYER RACK.
See the figure.
(g) Check that the RACKS and the
CROSSOVERS are seated correctly.
(h) Install:
• YOKE
• EVAPORATION COVERS
• WET SECTION COVER
(i) Connect the WATER DISCONNECT
[10] Close the TOP COVER.
LOCKING TAB (2)
TOP EXIT
RACK
DRYER
RACK
LOCKING
TAB (2)
1-7