Kodak X-Omat 270 RA Service Manual page 85

(c) Move the DETECTOR SWITCH
BRACKET down approximately another
1 - 2 mm (approximately 1/16 in.).
Be sure that the DETECTOR SWITCH
BRACKET remains in the vertical
position.
(d) Carefully, tighten the 2 SCREWS to
hold the DETECTOR SWITCH
BRACKET in position.
(e) Remove the 2.5 cm (1 in.) FILM STRIP
from between the ENTRANCE
DETECTOR ROLLERS.
ENTRANCE
DETECTOR
ROLLER
2B6845
NOTE
FILM STRIP
2.5 cm (1 in.)
Drive
Side
Feeding the Film Strip Between the Entrance Detector Rollers
[16] Adjust the non-drive side DETECTOR
SWITCH.
(a) Locate the DETECTOR SWITCH on
the non-drive side of the
PROCESSOR.
(b) Do Steps (a) - (e) on pages 6-26 and
6-27 for the DETECTOR SWITCH
BRACKET on the non-drive side of the
PROCESSOR. Insert the FILM STRIP
on the non-drive side of the
PROCESSOR.
H104_0370DCA
H104_0370DC
6-27