Kodak X-Omat 270 RA Service Manual page 28

• Check the direction of the WORM GEARS. See the figure below for correct installation on the
DRIVE SHAFT.
• When installing the DRIVE SHAFT, install a quantity of DRIVE SHAFT WASHERS until the DRIVE
SHAFT has minimum play from side to side.
[13] Reverse the above procedure to install new WORM GEARS and a new DRIVE SHAFT. Install the same
quantity of SHIMS that you removed in Step [10].
[14] Adjust the tension on the DRIVE CHAIN. See page 3-5.
DRYER END
3-4
IMPORTANT
DRIVE SHAFT
Checking the Direction of the Worm Gears
WORM GEAR (7)
FEED END
H104_0458BCA
H104_0458BA
2B6845