Removing The Racks With Solutions In The Tanks - Kodak X-Omat 270 RA Service Manual

Removing the Racks with Solutions in the Tanks

To install the RACKS, see page 1-7.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove:
• WET SECTION COVER
• EVAPORATION COVERS
• YOKE, see the figure on page 2-8
• FIXER/WASH CROSSOVER
• DEVELOPER/FIXER CROSSOVER
• DETECTOR CROSSOVER
[4] To remove the DEVELOPER RACK:
(a) Lift the DEVELOPER RACK slowly out
of the PROCESSOR. Tilt the
DEVELOPER RACK to drain the
developer into the developer TANK.
(b) Hold a DRIP TRAY under the
DEVELOPER RACK.
[5] To remove the FIXER RACK:
Do not allow fixer to contaminate the
developer solution.
• Use DRIP TRAYS.
• If removing both the FIXER RACK and the
DEVELOPER RACK, remove the
DEVELOPER RACK first.
• When removing the FIXER RACK, place the
SPLASH GUARD between the developer
and fixer TANKS. Lift the FIXER RACK
slowly and drain it before moving it to the
work station.
(a) Place the SPLASH GUARD between
the developer and fixer TANKS.
1-6
NOTE
SPLASH
GUARD
(b) Lift the FIXER RACK slowly out of the
PROCESSOR. Tilt the FIXER RACK
to drain the fixer into the fixer TANK.
(c) Hold a DRIP TRAY under the FIXER
RACK.
[6] To remove the WASH RACK:
(a) Disconnect the WATER DISCONNECT
from the non-drive side of the WASH
RACK. See the figure on page 2-8.
(b) Lift the WASH RACK from the WASH
TANK.
[7] To remove the TOP EXIT RACK:
(a) Rotate the TOP EXIT RACK a small
distance.
(b) Slowly and carefully lift the TOP EXIT
RACK from the PROCESSOR.
[8] To remove the DRYER RACK:
(a) If the PROCESSOR has a TOP EXIT
RACK, remove it. See Step [7].
(b) Lift the DRYER RACK straight up from
the PROCESSOR.
DRIP
TRAY
H108_0035ACC
H108_0035AA
2B6845