Adjusting The Alarm Volume On The 5600 Circuit Board - Kodak X-Omat 270 RA Service Manual

[7] Remove the 3 SCREWS, the 3 LOCK WASHERS, and the 3 WASHERS that hold the FILM DETECTOR
SHIELD to the 5600 CIRCUIT BOARD.
[8] Remove the FILM DETECTOR SHIELD.
[9] Disconnect CONNECTOR P/J 5602 and CONNECTOR P/J 5603.
[10] Remove the 3 STANDOFFS.
[11] Remove the 5600 CIRCUIT BOARD.
[12] Using EXTRACTION TOOL TL-4430, remove PROM U12 from the 5600 CIRCUIT BOARD. Install the
PROM U12 in the new 5600 CIRCUIT BOARD.
[13] Reverse the above procedure to install a new 5600 CIRCUIT BOARD and to assemble the
PROCESSOR.
[14] Check for correct operation of the DETECTOR SWITCHES. See page 6-21.

Adjusting the Alarm Volume on the 5600 Circuit Board

[1] Do Steps [1] - [3] on page 6-17.
[2] Adjust the sound of the alarm by rotating R5644. See the figure on page 6-17.
• clockwise for louder
• counterclockwise for
[3] Check for correct operation of the DETECTOR SWITCHES. See page 6-21.
6-18
for softer
2B6845