Removing The 5600 Circuit Board, The Universal Film Detector - Kodak X-Omat 270 RA Service Manual

Removing the 5600 Circuit Board, the Universal Film Detector

Possible damage from electrostatic discharge.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove:
• WET SECTION COVER
• DETECTOR CROSSOVER
• 3 SCREWS, the 3 LOCK WASHERS, and
the 3 WASHERS that hold the FILM
DETECTOR HOUSING
[4] Disconnect CONNECTOR P/J 5601 from the 5600 CIRCUIT BOARD.
[5] Remove the SCREW and the STRAIN RELIEF.
[6] Remove the FILM DETECTOR HOUSING and place it on a flat surface with the 5600 CIRCUIT BOARD
on the top.
SCREW (3)
LOCK WASHER (3)
WASHER (3)
FILM
DETECTOR
SHIELD
CONNECTOR
P/J 5602
2B6845
NOTE
Not all PROCESSORS have a STRAIN RELIEF.
STANDOFF (3)
Replacement of the 5600 Circuit Board
FILM DETECTOR
HOUSING
CONNECTOR
P/J 5601
R5644
5600 CIRCUIT
BOARD
FILM DETECTOR
HOUSING
SCREW (3)
LOCK WASHER (3)
WASHER (3)
H104_0317ACA
H104_0317AA
SCREW
STRAIN
RELIEF
CONNECTOR
P/J 5603
H104_0439HCA
H104_0439HA
6-17