Adjusting The Tension On The Drive Chain - Kodak X-Omat 270 RA Service Manual

Adjusting the Tension on the Drive Chain

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove:
• DRIVE SIDE PANEL
• EXIT PANEL
• DRIVE CHAIN COVER
[4] Loosen the 4 DRIVE MOTOR BOLTS from
the MOTOR BRACKET.
[5] Press down on the DRIVE MOTOR to tighten
the DRIVE CHAIN. Allow 5 mm (1/4 in.)
deflection of the DRIVE CHAIN at the center
of the DRIVE CHAIN.
[6] Tighten the 4 DRIVE MOTOR BOLTS.
[7] Install the:
• DRIVE CHAIN COVER
• EXIT PANEL
• DRIVE SIDE PANEL
2B6845
DRIVE
CHAIN
COVER
MOTOR
BRACKET
DRIVE CHAIN
SCREW (3)
WASHER (3)
LOCK WASHER (3)

Adjusting the Tension on the Drive Chain

DRIVE
MOTOR
SPROCKET
DRIVE MOTOR
BOLT (4)
H104_0147CCB
H104_0147CA
3-5