Replenishment System; Removing The Replenisher Strainer Assemblies And Screens - Kodak X-Omat 270 RA Service Manual

Replenishment System

Removing the Replenisher Strainer Assemblies and Screens

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Use 2 CLAMPS TL-2170 on the REPLENISHMENT HOSES on either side of the REPLENISHER
STRAINER.
[3] Loosen the 2 HOSE CLAMPS and remove the REPLENISHER STRAINER.
[4] Remove the CAP.
[5] Remove the SCREEN from the REPLENISHER STRAINER.
[6] Clean the SCREEN or, if necessary, install a new SCREEN.
[7] Check the O-RING for wear. If necessary, install a new O-RING.
[8] Reverse the above procedure to assemble.
Replacement of the Replenisher Strainer Assembly or Screens
2B6845
CLAMP
TL-2170
SCREEN
CAP
HOSE CLAMP (2)
REPLENISHER
STRAINER
O-RING
H104_0163BCA
H104_0163BA
5-13