Kodak X-Omat 270 RA Service Manual page 40

• When you install a new DRYER
HEATER, check that all wires are in
the correct openings in the PLENUM
ASSEMBLY COVER and are not
pinched.
• Install the WIRE HARNESS correctly. If the
WIRE HARNESS is too close to the DRYER
HEATER, the insulation on the wires may
be damaged. See the ''CORRECT'' figure
below on the right.
DRYER
HEATER
PLENUM
ASSEMBLY
COVER
INCORRECT
4-6
WIRE HARNESS
INCORRECT
Checking the Position of the Wire Harness
[9] Install the new DRYER HEATER.
[10] Check the wire positions. See the figure
below on the right.
[11] Reverse the above procedure to continue
assembling the PROCESSOR.
PLENUM
ASSEMBLY
COVER
CORRECT
CORRECT
DRYER
HEATER
WIRE HARNESS
H104_0387BCB
H104_0387BA
2B6845