Adjusting The Dryer Temperature; Film-Feeding Procedure - Kodak X-Omat 460 RA Operator's Manual

Adjusting the Dryer
Temperature
Film-Feeding
Procedure
636736
Use the main menu to adjust the temperature of the dryer. You do not need to use
the access code. You may select a different dryer temperature for each cycle and
store them separately.
Adjust the dryer temperature to the lowest
possible temperature that still allows good drying.
[1] To change the dryer temperature press the—
(a) /\ key to increase the temperature.
(b) \/ key to decrease the temperature.
|
/\ \/
|
DRYER DRYER
|
Sheet Film: See Figure 11 for the correct film-insertion procedure. Arrows indicate
the direction in which films are transported into the processor. Feed films square with
the edge of the film guide.
Insert single-emulsion films emulsion-side-up into the processor aligning the film edge
with the edge of the film guide.
• Do not try to pull the film back out of the processor once you have fed
them into the processor.
• Do not allow more than 100 films to accumulate in the receiving bin at one
time.
Roll Film (35 mm): Use a sheet of film as a leader. Make sure that the sheet film is
wider than the roll film and at least 17.8 cm (7 inches) long. Using 1-inch-wide tape,
such as 3M SCOTCH Brand Polyester Film Tape No. 850, fasten the film to the
leader, making sure that the adhesive side of the tape is not exposed. Most other
types of tape are not acceptable, because their bases are soluble in the processing
solutions.
IMPORTANT
| | |
SELECT DISPLAY GO TO
| | |
CYCLE FIX SETUP
| | |
TEMP
37