Removing The Drive Motor Controller A2 - Kodak X-Omat 270 RA Service Manual

Removing the Drive Motor Controller A2

Possible damage from electrostatic discharge.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the EXIT PANEL.
[4] Extend the ELECTRICAL BOX.
[5] Open the ELECTRICAL BOX.
[6] Remove the 4 SCREWS.
If the PROCESSOR is not on a
STAND, you may need to remove the
ELECTRICAL BOX from the
PROCESSOR for easier access to the
4 SCREWS.
[7] Record the positions of the wires. See
page 6-14 for the correct wire connections.
[8] Disconnect the 7 wires.
[9] Disconnect the CONNECTOR A2P/J-1 from
the DRIVE MOTOR CONTROLLER. See the
figure on page 6-14.
[10] Remove the DRIVE MOTOR CONTROLLER.
[11] Reverse the above procedure to install a new
DRIVE MOTOR CONTROLLER and to
assemble the PROCESSOR.
2B6845
NOTE
ELECTRICAL
BOX
Replacement of the Drive Motor Controller
DRIVE MOTOR
CONTROLLER
SCREW (4)
H104_0441CCA
H104_0441CA
6-13