Kodak X-Omat 270 RA Service Manual page 62

[4] Remove the FEED SHELF.
The SCREWS that hold the FEED
END PANEL are different sizes.
Record the original positions of the
SCREWS for easier installation.
[5] Remove from the FEED END PANEL:
• 9 SCREWS
• 9 LOCK WASHERS
• 9 WASHERS
FEED END
PANEL
CB1
SCREW (9)
WASHER (9)
LOCK WASHER (9)
6-4
NOTE
SCREW (4)
LOCK WASHER (4)
WASHER (4)
FEED
SHELF
Removal of the Feed End Panel
[6] Remove the 2 BRACKETS that hold the
PROCESSOR to the wall.
[7] Move the PROCESSOR about 15 cm (6 in.)
from the wall.
[8] Remove the FEED END PANEL from the
PROCESSOR.
[9] Reverse the above procedure to assemble the
FEED END PANEL.
AIR
EXHAUST
H104_0172DCA
H104_0172DA
2B6845