Installation Of The New Style Film Detector Switches, S1 And S2 - Kodak X-Omat 270 RA Service Manual

Installation of the New Style Film Detector Switches, S1 and S2

Improved DETECTOR SWITCH BRACKETS are now available. For installation, the following
parts are necessary. The older style DETECTOR SWITCH BRACKETS are not available.
[1] Deenergize the PROCESSOR. See page 1-5.
[2] Remove:
• WET SECTION COVER
• DETECTOR CROSSOVER
[3] Remove the existing SWITCH PLATE
ASSEMBLIES.
(a) From the drive side of the FILM
DETECTOR HOUSING, remove and
keep the 2 ASSEMBLY SCREWS that
hold the SWITCH PLATE ASSEMBLY
to the FILM DETECTOR HOUSING.
H104_0371BCB
H104_0371BA
Removing the Old Style Switch Plate Assembly from the Film Detector Housing
2B6845
Part No.
981892 Detector Switch Bracket, Non-Drive Side
981893 Detector Switch Bracket, Drive Side
288235 Nut Plate
non-drive side
FILM DETECTOR
HOUSING
NOTE
Description
(b)
(c)
SWITCH PLATE
ASSEMBLY
drive side
ASSEMBLY
SCREW (2)
SCREW
(2)
Quantity
1
1
2
Remove and keep the 2 SCREWS that
hold the DETECTOR SWITCH to the
SWITCH PLATE ASSEMBLY.
Remove and discard the existing
SWITCH PLATE ASSEMBLY.
ADJUSTING
SCREW
DETECTOR SWITCH
6-19