Fixer Recirculation System; Removing The Fixer Heater Hr2 - Kodak X-Omat 270 RA Service Manual

Fixer Recirculation System

Removing the Fixer Heater HR2

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the DRIVE SIDE PANEL.
[4] Remove from the RECIRCULATION PUMP:
• SPLASH COVER
• 2 SCREWS
• 2 LOCK WASHERS
• 2 WASHERS
[5] For access to the FIXER THERMOWELL,
move the RECIRCULATION PUMP.
SCREW (2)
LOCK
WASHER (2)
WASHER (2)
SPLASH
COVER
Removal of the Splash Cover
2B6845
RECIRULATION
PUMP
H104_0470GCA
H104_0470GA
[6] Remove the 2 SCREWS from the FIXER
THERMOWELL.
[7] Use 2 CLAMPS TL-2170 on the 2 HOSES to
the FIXER THERMOWELL.
[8] Move the FIXER THERMOWELL for access
to the FIXER HEATER.
[9] Remove the FIXER HEATER from the FIXER
THERMOWELL.
[10] Disconnect the CONNECTOR P/J 19.
CONNECTOR P/J 19
FIXER
HEATER
FIXER
THERMOWELL
H104_0162CCC
H104_0162CA
Replacement of the Fixer Heater
HEATER
LOCATOR
SCREW
(2)
CLAMP
TL-2170
5-9