Removing The Drive Motor B6 And The Gear Box - Kodak X-Omat 270 RA Service Manual

Removing the Drive Motor B6 and the Gear Box

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove:
• DRIVE SIDE PANEL
• EXIT PANEL
• DRIVE CHAIN COVER
[4] Loosen the 4 DRIVE MOTOR BOLTS from
the MOTOR BRACKET.
[5] Lift the DRIVE MOTOR and remove the
DRIVE CHAIN.
[6] Remove the SPROCKET from the DRIVE
MOTOR.
DRIVE CHAIN
COVER
2B6845
DRIVE
CHAIN
SPROCKET
Replacement of the Drive Motor and the Gear Box
[7] Remove the 4 MOUNTING NUTS, LOCK
WASHERS, and WASHERS from the DRIVE
MOTOR.
[8] Move the DRIVE MOTOR and the GEAR
BOX for access to CONNECTOR P/J 22.
[9] Disconnect the CONNECTOR P/J 22 and the
CABLE SHIELD CONNECTOR.
[10] Remove the DRIVE MOTOR and the GEAR
BOX.
[11] Reverse the above procedure to install a new
DRIVE MOTOR and a new GEAR BOX.
[12] Adjust the tension on the DRIVE CHAIN. See
page 3-5.
WASHER
LOCK
WASHER
MOTOR
MOUNTING
BRACKET
NUT (4)
DRIVE
MOTOR
GEAR
BOX
CABLE
SHIELD
CONNECTOR
CONNECTOR
P/J 22
H104_0412HCB
DRIVE
MOTOR
BOLT (4)
H104_0412HA
3-7