Wash System; Removing The Water Solenoid Valve L1 - Kodak X-Omat 270 RA Service Manual

Wash System

Removing the Water Solenoid Valve L1

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Remove the NON-DRIVE SIDE PANEL.
[3] Stop the flow of water to the PROCESSOR.
(Turn the water off.)
Disconnect the water HOSE very
slowly to release the pressure in the
HOSE.
[4] Disconnect the HOSE to the water supply
INLET to the PROCESSOR at the WATER
SOLENOID VALVE.
[5] Loosen the 2 HOSE CLAMPS and remove,
from the BULKHEAD PANEL, the HOSES for:
• FIXER OVERFLOW
• DEVELOPER OVERFLOW
SCREW (2)
LOCK WASHER (2)
WASHER (2)
5-12
NOTE
BULKHEAD
PANEL
Replacement of the Water Solenoid Valve
[6] Remove the 2 SCREWS, the 2 LOCK
WASHERS, and the 2 WASHERS from the
WATER SOLENOID VALVE.
[7] Loosen the HOSE CLAMP and remove the
WATER HOSE from the WATER SOLENOID
VALVE.
[8] Disconnect the wires from the WATER
SOLENOID VALVE.
[9] Remove the WATER SOLENOID VALVE.
[10] Reverse the above procedure to install a new
WATER SOLENOID VALVE and to assemble
the PROCESSOR.
IMPORTANT
Check for leakage at the WATER
SOLENOID VALVE.
water
supply
INLET
DEVELOPER
OVERFLOW
FIXER
OVERFLOW
WATER
SOLENOID
VALVE
HOSE
H104_0446HCA
H104_0446HA
2B6845