Removing The Developer Heater Hr1 - Kodak X-Omat 270 RA Service Manual

Removing the Developer Heater HR1

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the DRIVE SIDE PANEL and the
EXIT PANEL.
[4] Drain the DEVELOPER TANK to below the
RECIRCULATION OUTPUT opening.
[5] Use a CLAMP TL-2170 on the longer HOSE
to the DEVELOPER THERMOWELL.
[6] Disconnect the CONNECTOR P/J 20.
[7] Remove the DEVELOPER HEATER.
• Check that the internal HEATER
LOCATOR is in the correct position
inside the DEVELOPER
THERMOWELL.
• Do not overtighten the parts when you
install the DEVELOPER HEATER.
• Use SEALANT TL-3230 when installing the
DEVELOPER HEATER into the
DEVELOPER THERMOWELL. Use only
TL-3230. Any other SEALANT will corrode
the plastic in the THERMOWELL. See the
instructions packed with the SEALANT.
[8] Reverse the above procedure to install the
new DEVELOPER HEATER.
[9] Check for leakage at the DEVELOPER
THERMOWELL.
5-4
HEATER
8.38 0.25 cm
LOCATOR (3.3 0.1 in)
HEATER
LOCATOR
DEVELOPER
THERMOWELL
CONNECTOR
P/J 20
HEATER
LOCATOR
DEVELOPER
HEATER
+
-
+
-
+
13.9 0.25 cm
-
(5.5 0.1 in)
RECIRCULATION
OUTPUT
SCREWS
CONNECTOR
P/J 26
+
-
H104_0444BCA
H104_0444BA
CLAMP
TL-2170
H104_0158CCC
H104_0158CA
2B6845