Processor Overview; Identifying And Removing The Covers And Panels - Kodak X-Omat 270 RA Service Manual

Processor Overview

Identifying and Removing the Covers and Panels

Before you do most of the procedures in this service manual, you must remove certain PANELS or COVERS
from the PROCESSOR. To remove the FEED END PANEL, see page 6-3.
To remove the DRIVE SIDE PANEL, the NON-DRIVE SIDE PANEL, or the EXIT PANEL:
[1] Lift the TOP COVER.
[2] Loosen the 2 CAPTIVE SCREWS on the PANEL to be removed.
[3] Lift the PANEL to release it from the 2 CLIPS under the PANEL.
TOP
COVER
NON-DRIVE
SIDE
PANEL
2B6845
STAND
SIDE PANEL

Identifying and Removing the Covers and Panels

CAPTIVE
SCREW
FRONT
PANEL
CLIP
DRIVE
SIDE PANEL
EXIT
PANEL
H104_0460DCA
H104_0460DA
1-3