Kodak X-Omat 270 RA Service Manual page 93

(c) Drain the chlorine bleach solution, and
rinse the system thoroughly with water
before returning the PROCESSOR to
normal use.
• Drains must be made of chemically
resistant, non-corrosive material.
Use PVC or the equivalent.
• The drain must have a minimum diameter of
7.6 cm (3 in.) and be free of obstruction.
• Drain service must comply with all local
codes.
[29] Correctly route the WASH DRAIN HOSE to
slope down toward the WASH DRAIN. If
necessary, use REINFORCED HOSES that
resist making small bends. Right angle
ELBOW FITTINGS are also available. The
Part Numbers are:
• 696442 - Reinforced Hose, 5/8-in. I.D.
Order by the foot.
• 1C4521 - Elbow Fitting, 5/8 in.
• 696441 - Reinforced Hose, 1-in. I.D. Order
by the foot.
• 1C4524 - Elbow Fitting, 1 in.
SPRING
SPADE
2B6845
[30]
[31]
[32]
Cleaning the Spring Spades
Check the DRIVE CHAIN.
(a) If the DRIVE CHAIN is dry, apply
lubricant to the DRIVE CHAIN. Use
NLG1 - No. 2 LITHIUM BALL AND
ROLLER BEARING GREASE TL-2324.
(b) If the DRIVE CHAIN is rusty, remove it
and install a new DRIVE CHAIN.
(c) Adjust the tension of the DRIVE
CHAIN. See page 3-5.
Check the SPRING SPADES on the LEVEL
SENSOR PROBES for corrosion. If
necessary, clean or install new SPRING
SPADES.
Check the operation of the DETECTOR
SWITCHES. See page 6-21. If necessary,
adjust the DETECTOR SWITCHES. See
page 6-23.
H104_0383BCB
H104_0383BA
7-7