Removing The Developer Thermistor Rt1 - Kodak X-Omat 270 RA Service Manual

Removing the Developer Thermistor RT1

[1] Deenergize the PROCESSOR. See page 1-5.
[2] Lift the TOP COVER.
[3] Remove the DRIVE SIDE PANEL.
[4] Drain the DEVELOPER TANK until the
developer is below the RECIRCULATION
OUTPUT opening.
[5] Use a CLAMP TL-2170 on the longer HOSE
to the DEVELOPER THERMOWELL.
[6] Disconnect the CONNECTOR P/J 26.
[7] Remove the DEVELOPER THERMISTOR
RT1 from the DEVELOPER THERMOWELL.
• Use SEALANT TL-3230 on the
DEVELOPER THERMISTOR when
installing the DEVELOPER
THERMISTOR in the DEVELOPER
THERMOWELL. Use only TL-3230.
Any other SEALANT will corrode the
plastic in the THERMOWELL.
• Do not overtighten the parts when installing
the DEVELOPER TERMISTOR.
[8] Reverse the above procedure to install a new
DEVELOPER THERMISTOR.
[9] Check for leakage at the DEVELOPER
THERMOWELL.
5-6
DEVELOPER
THERMOWELL
CONNECTOR
P/J 26
Replacement of the Developer Thermistor
CLAMP
TL-2170
RECIRCULATION
OUTPUT
DEVELOPER
THERMISTOR
H104_0158CCB
H104_0158CA
2B6845