Table of Contents
Advertisement
Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
Upper Inlet Display: Set to Disabled if you want to hide the Inlet 2 temperature for
•
units with dual inlets where the upper inlet is not utilized.
BST Return Display: Enables/ disables display of the BST Return Header sensor.
•
It should be enabled only when utilizing a BST return header sensor.
Beeper: Enables/disables the audible fault alarm.
•
Run Cycles/Run Hours: Displays the number of run hours/run cycles since the last
•
system reset. Both can be reset to 0 (or any other number).
Reset Common Settings: To reset "common" settings and restored default
•
values, press Yes, then press Yes again when asked to confirm.
Clear Fault Log: To clear the Unit Event History (see
•
History), press Yes, then press Yes again when asked to confirm.
Reset All Settings: To reset all settings and restored default values, press Yes,
•
then press Yes again when asked to confirm.
6.2.2 Front Panel Configuration
The Front Panel Configuration screen allows you to modify the Controller's front panel and the
touchscreen timeout setting.
UPPER-LEFT DISPLAY
Figure 6.2.2-1: Unit: Controller Front Panel – Upper Portion
Main Menu → Advanced Setup → Unit → Front Panel
1. Go to:
Figure 6.2.2-2: Unit: Front Panel Configuration Screen
•
OMM-139_E
8/25/2020
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Section 7.7 Unit Event
MULTI-FUNCTION BAR
UNIT OF MEASURE
UPPER-RIGHT DISPLAY
Configuration.
Page 97 of 196
Hide quick links:
Advertisement
Table of Contents
