Analog Inputs - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
3. Depending on your choice, the following parameters appear (# = 1, 2 or 3, depending on the
value of Select Output):
Aout # Name:
•
o Aout 1 and Aout 3: Can be set to Fire Rate or Other.
o Aout 2: Can be set to Valve, Fire Rate or Other.
Aout # Signal: Displays the signal for this output: Aout 1 = 1-10v, Aout 2 and
•
Aout 3: Appears only if Select Output = Spare Analog Out 3: A read-only
display of the signal associated with Spare Analog Out 3.
Aout # Min Fire Rate and Aout # Max Fire Rate: Enter the minimum and
•
maximum fire rates. The analog voltage signal is linearly mapped to the firing rate
values. (Min Fire Rate Range: 0% to 50%, Max Fire Rate Range: 51% and 100%).
Rem Spr Aout # Add: (Remote Spare Analog Output # Address, where # is the
•
output chosen in Step 2, 1, 2 or 3): Specify the address of the unit to which the
analog output signal is sent. (Range: 0 to 16)

6.5.4 Analog Inputs

Analog Input menu allows you to configure all available programmable analog inputs.
Main Menu → Advanced Setup → Ancillary Device → Analog
1. Go to:
Figure 6.5.4: Ancillary Device: Analog Inputs Screen
2. Choose the analog input you want to configure. These inputs attach to the unit's I/O box
strip J5, on the pins shown below.
•
Spare Analog In 1 – pin 3 Spare Analog In 1+
•
Spare Analog In 2 – pin 5 Spare Analog In 2+
•
Spare Analog In 3 – pin 1 Spare Analog In 3+
3. Select the name for the input chosen in Step 2 in the Name field. (Note, the combination
chosen in Steps 2 and 3 determines what appears in
•
Not Assigned
•
Swing V1 Fdbk
•
Blr VSP Fdbk
•
SmartPlate VP
•
OMM-139_E 8/25/2020
•
Remote Setpt 2
•
Swing V2 Fdbk
•
DHW VSP Fdbk
•
NOx
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Inputs.
pin 4 Spare Analog In 1-
pin 6 Spare Analog In 2-
pin 2 Spare Analog In 3-
Section 3.3.3: Analog Inputs.)
Page 154 of 196