Table of Contents
Advertisement
Edge [ii] Controller Operation Manual
SECTION 4: DIAGNOSTICS
4.6.1 IP Network
The IP Network option is used to check the IP interface used by onAER or BAS.
Main Menu → Diagnostics → Comm & Network → IP
1. Go to:
Network.
Figure 4.6.1: Comm & Network: IP Network Screen
2. View the status of the available parameters.
4.6.2 BAS
If the unit is part of a Building Automation System (BAS), the BAS screen provides a read-only
display of various communication parameters. The screen that appears depends on the
communication protocol specified in the BAS parameter in Advanced Settings → Comm &
Network → BAS (see
Section 6.4.1: BAS (Building Automation
System))
Main Menu → Diagnostics → Comm & Network →
1.
Go to:
BAS.
BAS = BACnet IP
BAS = BACnet MSTP
Figure 4.6.2: Comm & Network: BAS Screen
2. View the status of the available parameters.
•
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
OMM-139_E
8/25/2020
Page 85 of 196
Hide quick links:
Advertisement
Table of Contents
