Watts AERCO Edge [ii] Operation Manual page 27

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
2. If you chose Constant Setpoint in Step 1, the Other Heating Constant Setpoint screen
appears. Specify the Unit Other Setpoint. Pressing Next takes you to the Select BAS
Mode screen; skip to
Figure 2.2.3-3: Standalone – Other: Other Heating Constant Setpoint Screen
3. If you chose Remote Setpoint in step 1, the Select Remote Setpoint Type screen
appears. Choose how the unit will access the setpoint, then press Next.
Figure 2.2.3-4: Standalone – Other: Select Remote Setpoint Type Screens
A. If you chose either 4-20mA or 0-20mA the Other Analog Input screen appears.
Configure the following parameters:
Figure 2.2.3-5: Standalone – Other: Other Analog Input Screen
Enter the upper and lower limits of the "other" setpoint in the Unit Other
•
Setpt Low Limit and Unit Other Setpt High Limit parameters.
•
Pressing Next takes you to the Select BAS Mode screen; skip to
Completing the Installation
•
OMM-139_E 8/25/2020
Section 2.4: Completing the Installation
for instructions
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
for instructions.
Section 2.4:
Page 27 of 196