Ez Setup: Bst Manager - Domestic Hot Water Application - Watts AERCO Edge [ii] Operation Manual

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
A. If you chose Network, Direct or BAS, the Space Heating Outdoor Reset screen
appears.
•
Fill in the four OAR temperature and setpoint settings, and the Warm Weather
Shutdown temperature; they will be used to create the associated OATR curve,
which the controller will use to compute the setpoint based on outside
temperature.
•
Pressing Next takes you to the Select BAS Mode screen; skip to
Completing the Installation
Figure 2.3.2.1.1-7: BST Manager – Space Heating: Space Heating Outdoor Reset
B. If you chose Off, the Select BAS Mode screen appears. Skip to
Completing the Installation
2.3.2.1.2 EZ Setup: BST Manager – Domestic Hot Water Application
Complete these instructions only if you chose Domestic Hot Water (DHW) at the end of
Section 2.3.2.
Figure 2.3.2.1.2-1: BST Manager – DHW: Select Your Boiler Application
•
OMM-139_E 8/25/2020
for instructions.
for instructions.
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Section 2.4:
Section 2.4:
Page 37 of 196