Ez Setup: Bst Manager - Single Application; Ez Setup: Bst Manager - Space Heating Application - Watts AERCO Edge [ii] Operation Manual

For benchmark boilers
Table of Contents

Advertisement

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
10. The Select Your Boiler Application screen appears. Chose one or any two boiler
applications that this BST cascade will run; the selected application(s) turn green. The
Other option could be for a snowmelt, radiated heating or any tertiary boiler water
application. Press Next to continue, then complete the instructions in the one section below
that corresponds to the application(s) you chose:
For a single application, go to:
o
Section 2.3.2.1.1: Space Heating (SH)
o
Section 2.3.2.1.2: Domestic Hot Water (DHW)
o
Section 2.3.2.1.3: Other
For two applications, go to:
o
Section 2.3.2.2.1: Space Heating & Domestic Hot Water
o
Section 2.3.2.2.2: Domestic Hot Water & Other
o
Section 2.3.2.2.3: Space Heating & Other
Figure 2.3.2-8: BST Manager: Select Boiler Applications Screen
EZ Setup: BST Manager – Single Application
If a single application was chosen above, complete the instructions in the one section below
that matches that Application.
2.3.2.1.1
EZ Setup: BST Manager – Space Heating Application
Complete these instructions only if you chose Space Heating at the end of Section 2.3.2.
Figure 2.3.2.1.1-1: BST Manager – Space Heating: Select Your Boiler Application
OMM-139_E
8/25/2020
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Page 34 of 196

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents